CONSIGLI UTILI

 

            

Fili Metallici: per ricamare in maniera più agevole (il filo metallico è ostico!) si può prendere una gugliata di filo metallico ed una di mouliné della stessa gradazione!Ricamare sarà più semplice!(Annamaria Ass. IL FILO CHE CONTA).

Quando iniziate un ricamo: ricordatevi di avere sempre le mani perfettamente pulite: potreste sporcare la tela e far perdere al filo la propria freschezza.               

Non indossate mai abiti scuri: è preferibile ricamare indossando un grembiule bianco. Da evitare anche qualunque tipo di maglione di lana, potrebbe invadere di peluchi la vostra tela.

Riguardo alla tela: lasciate un margine abbondante tutt'intorno per mantenere un bordo che in caso di errore vi servirà per correggere le dimensioni del vostro lavoro. Il bordo va sempre protetto con un orlo, uno zig zag o applicando del nastro adesivo.

Usate le forbici per tagliare il filo: la saliva bagna e sporca il filato.

Gli aghi per ricamare: sono di acciaio, piuttosto lunghi e sottili con la punta arrotodata.Si consiglia di acquistare la gamma completa di aghi delle varie grossezze, per poter scegliere, di volta in volta, la misura più adatta.

Non bagnate mai la tela prima di ricamarla: l'appretto che c'è sopra vi aiuterà sia nel lavoro che nel risultato finale.

Non usate gugliate troppo lunghe: fa perdete brillantezza al filato e provoca nodi. Se si arrotola, lasciate pendere l'ago e in pochi istanti il filo tornerà come prima.

Sul filo: non ricamate con il filo troppo teso è antiestetico e rovina il ricamo.Ricordate di non fare mai nodi! Essi sono ammessi solo per punti singoli e solitari.Non iniziate con il filo scuro sotto le crocette eseguite con il filo chiaro, si noterebbe una linea scura davvero brutta!

Perline: Per inserire le perline occorre utilizzare un ago finissimo. Si applicano sul tessuto con la stessa tecnica del punto croce e con il filato delle crocette antecedenti.

Se non avete dimestichezza col punto nodini: potete applicare una perlina al posto del punto stesso.

Ogni volta che riponete il lavoro: abbiate cura di piegarlo accuratamente, con l'accortezza di tenere il diritto del lavoro all'interno della piegatura. Avvolgetelo in un telo bianco ( potete usare anche un vecchio lenzuolo).

Se hai dei consigli da aggiungere scrivimi!

HOME

  Back

 

 

 

ADDITIONAL HINTS

     

 

A problem with aida comes when stitching a pattern that incorporates 1/4 and 3/4 stitches: It’s advisable to use a sharp needle (rather than the blunt needle usually used when cross-stitching) to poke through the center of the square/block to create the 1/4 stitch.

 

Hoop or Hand:The stitching "in the hand"tends to make stitching quicker since you get a needle-down-and-needle-up motion all in one stroke.

 

Your project: should be stored in a bag or workbasket when not being stitched to protect it from dust, spills, etc.

 

The floss may get twisted: so after you make several stitches, let your needle dangle to untwist the floss.

 

The floss:It is recommended that you use approximately 18" lengths of thread when stitching your project. This will help to avoid knotting, twisting or fraying of the thread while you work.
 

The tip:Run your length of floss through a damp sponge before separating the plies - this will keep the strands from twisting and getting knotted up as you separate them.

 

The french knot: if you still have problems with french knots is to substitute seed beads for french knots. Put your bead on your needle and string it through the length of the floss. Bring your needle back down through the same hole of the fabric where you started, pulling the bead tight against the fabric - making sure that your floss doesn't twist and tangle as you do this.

 

About fabric: Always make sure to cut your fabric large enough - you want to leave a border of at least 4 inches around ALL SIDES of your pattern.

It is always better to have extra fabric on the edges, you can always trim them down, afterwards, and if you have miscalculated your stitching, you may end up with not enough fabric to complete your design.

 

Relax as you stitch: Your stitches should lay flat on your fabric and not distort the holes or the fabric.

 

Needles :When working counted cross stitch you will need blunt tapestry needles of various sizes depending on your fabric

 

If you know addintional hints mail me!